Buy Pump SMD 14-13S2-1A SMD 14 Pomp
Pump SMD 14-13S2-1A SMD 14 Pomp

Pump SMD 14-13S2-1A SMD 14 Pomp

Products from producer
In stock
850 UAH
Ukraine, Melitopol
(View map)
Display phones
7 years on Allbiz
Quickly responds
Technical characteristics
  • BrandСМД 14
  • Country of manufactureUkraine

Pump SMD 14 Code/article: 14-13C2-1A Application: TDT-55 tractor. SMD-14 engine

The water pump of the SMD-14 engine, as well as at some other engines, represents the general knot with the fan. A pump housing (in drawing of poses. 25) with a cover (poses. 13) it is fixed on forward part of the block of cylinders by bolts. Between butt surfaces of a cover and the case laying is established (poses. 23). In the case of a pomp 14-13C2-1A the roller is placed (poses. 7), established on bearings (poses. 8) ball type. To a nave (poses. 4), the spline fixed on the roller and a nut, attached by bolts the pulley with fan blades (poses. 3, 1) receiving rotation from the engine crankshaft through a wedge-shaped belt (poses. 2). On the back end of a shaft the krylchatka is fixed (poses. 16), placed in a water cavity of a cover. Rotation of a krylchatka creates centrifugal forces which throw out water in a forcing cavity. This cavity has spiral expansion in the direction of rotation of a krylchatka that provides reduction of speed of water, but increase in its pressure. At a water exit from interbladed space of a krylchatka in her center discharge thanks to which water arrives a continuous stream from an absorption cavity here is created. In a cover (the top part) the opening for removal of air is executed from the pump when filling with water of system. In the lower part of a cover the opening for water discharge is located. For prevention of leak of water from a pump cavity there is a special consolidation. Washer (poses. 21), made of textolite, enters ledges grooves of a krylchatka, rotating together with her. Spring (poses. 17) densely presses a washer to a plug end face (poses. 24). Cuff (poses. 20) blocks access to water to space between a washer and the roller. Greasing of bearings is carried out by solid oil. For prevention of leak of greasing epiploons are installed in the case of a pomp.

Contact the seller
Pump SMD 14-13S2-1A SMD 14 Pomp
Pump SMD 14-13S2-1A SMD 14 Pomp
by the goods
Your message must contain at least 20 symbols. The message must not be more than 2000 symbols.
Obligatory field is not filled
The field is wrongly filled
The field is wrongly filled
Shipping method
ClearSelected items: 0