- Country of manufactureChina
- Profile 425 на 205 на 355 mm
- Number of phases1
- Protection ratingIP21
- Input Voltage220 V
The welding inverter of the CT series is a compact multipurpose welding machine which allows to make three types of works at once:
- argonno-arc welding on a direct current (TIG DC);
- manual arc welding (MMA DC);
- plasma cutting;
The welding ST-416 inverter is intended for welding and cutting of such metals as carbonaceous and stainless steels, cast iron, copper, titanium, non-ferrous metals. In the mode of plasma cutting connection to the compressor or the highway of compressed air with pressure of 5-6 Atm is in addition necessary. For welding works the compressor is not required. The mode air plazmenoy cuttings, as well as possible, is suitable for aluminum cutting as to cut preparations from aluminum or its alloys in other ways of thermal cutting difficult. All necessary accessories for argonodugovy welding and plasma cutting are included in a package of the device.
The welding CT-416 inverter will become for you the irreplaceable assistant when carrying out different types of repair installation works, in automobile repair shop, a garage or the building site. The device is equipped with function of contactless excitement of an arch, has high efficiency, low level of energy consumption, provides high quality of welding and cutting, is reliable in work. The Efficiency (E) of this equipment makes more than 85%. The device possesses the built-in system of automatic compensation of the entering mains voltage that allows it to support stable work at fluctuations of network within admissible range.
This welding inverter is manufactured on modern element base with use of MOSFET of transistors and to use of the principle of pulse-width modulation thanks to what differs in stable, reliable and effective work. Length of an arch and fluctuation of mains voltage do not influence stability of value of welding current at implementation of TIG and MMA of welding. Universality mobility and compactness of a source, and also a possibility of connection to household network 220B open wide borders for its application.
Bystry and high-quality cutting of metal air by means of air and plasma installation requires only a supply of compressed air by pressure not less than 5 atm and power supply from single-phase network of 220B. Cutting of metals is made by a supernarrow stream of high-temperature plasma which is formed when passing compressed air through the electric discharge which is supported in a plasma torch of installation.
Delivery set ST welding machine 416:
- TIG WP17 Torch,
- short cap,
- long cap,
- grip case
- the nozzle is ceramic,
- cable with an elektrododerzhatel,
- the return cable with the plug of grounding of 3 m,
- cable tip,
- the plasmatron PT 31 (with a set of expendables)