- Country of manufactureRussia
- Plant manufacturerмотор-мастер
The autonomous tester of MM-TK-01 ignition coils is applied to check of single and dual coils, ignition modules (with the built-in powerful key), and also individual ignition coils.
Characteristics of MM-TK-01:
Source voltage is from 11 to 18 Volts
The consumed current to 3,5A
Protection against polarity reversal, against short-circuit in the primary winding of the coil
Pulse width of accumulation from 1,2 to 3,5ms
Imitation of turns of the engine (for DIS systems) from 600 to 6000 RPM
It should be noted that the device is made on rigid logic, without use of the microprocessor. This feature allows the device to run smoothly in the conditions of strong electromagnetic hindrances.
Raspinovka of the output connector corresponds to raspinovka of Scan Master USB devices and the Test Master therefore it is possible to use standard cable for the test of ignition coils from these devices.
The tester of MM-TK-01 is autonomous, i.e. for its use the personal computer is not necessary.
Operating procedure with tester of ignition coils:
Before testing it is recommended to ring out multimeter the coil regarding short circuit of the primary winding on secondary since the device of this fault cannot reveal.
To connect cable of testing of coils to the device. To connect other end of cable to the ignition coil connector. (The connector for connection of individual coils is marked by red thermoshrinkage). To connect the high-voltage discharger to the tested coil (coils). Cables of the device need to be placed as it is possible further from the discharger since at hit of high tension on them the device will fail.
Further to power the adapter from source (for example, from joint stock bank avtobilya) and to press the ON button.
During the test if necessary regulate pulse width and turns of the engine the corresponding handles on the device body.
The attention, is forbidden!
1. To disconnect coils from connectors at the started test and not powered off tester of coils.
2. To start tests without dischargers since it will immediately lead to failure of the ignition coil or module and tester.
3. The cable of coils when using has to be direct if it is twisted by rounds, then it can become prichiy failure of tester of coils.
- Guarantee: 12 months