- Country of manufactureSpain
- Weight25 kg
- Number of componentsOne-component
- Application MethodManual
- Consumption0.7-1.2 kg/m²
- PurposeFor the floor
To be applied on concrete, a brick, an old bituminous roof, the bituminous old base!
Impermelizante E-88 - the unicomponent elastic structure made on the basis of pitch with the improved property of water tightness at any not to weather.
Good resistance and excellent elasticity.
The layer of IMPERMIBILIZANTE E-88 shows resistance to big fluctuations of temperature without losing the water tightness or soprotivlyaemy ability.
Joints, connections between a roof and walls
Advantages: Moisture and water tightness of various surfaces Prost in application allows to reach effective. To get divorced water. Excellent resilience, both at positive, and with a negative pressure of water. Good adhesion to various surfaces Water tightness Resistance to the cycles "frost thaw" Plasticity at low temperatures does not demand special alignment of a surface
It can be used as a finishing covering without additional finishing
Mixing: Before use a product carefully to mix, add water in the ratio of 25 kg
IMPERMIBILIZANTE E-88 is required 2,5 liters of water.
One layer - 1,5-2 kg on m, at a thickness of layer from 1 to 1,5 mm
UPAKOVKA:IMPERMIBILIZANTE E-88 is packaged in plastic containers on 25 kg
The product has to be stored in densely closed container protected from a frost.
Period of storage of 12 months.
Technology of drawing
Preparation of a surface:
Before drawing IMPERMIBILIZANTE E-88 the surface has to be surveyed for identification of existence of defects: the cavities, openings damaged and not condensed construction seams, cracks of zones with "friable" concrete. These zones have to be repaired by materials PROKVIK if there is an active water inflow, or PREMHOR if there is no water inflow. The surface on which to be applied to IMPERMIBILIZANTE E-88 has to be dry, cleared of frost, dirt of dust, fatty pollution.
Method of application: Before works the structure needs to be mixed in a container, having added water in the ratio 10:1, stirring to homogeneous mass.
Way of drawing: The elastic structure should be put on all surface with a brush or the roller. To leave to dry - 8 hours, before full hardening. If there is a need, then the second layer to be put not earlier than in 8 hours.
Contraindications and special recommendations:
It is not recommended to use during a rain. It is not recommended to put structure if in the next 12 hours the frost is expected.
It is not recommended to use at a temperature below - 12 °C.
It is not recommended to apply if humidity of air exceeds 80%
Apply for more detailed information on use of these materials to our experts.