Hydraulics on a fuel truck, the tractor, the manipulator, the timber carrying vessel - a gidrofikation of a cargo car, installation of the hydraulic equipment on special equipment.
The hydraulics allows to expand functionality of any commercial vehicle. It is necessary to refer installation of cranes manipulators, installation of hydraulics for a body inclination to a gidrofikation of special equipment, etc. possible options of a gidrofikation. The cost of works on a gidrofikation is considerable, for this reason carry out them only if the car is constantly used in a certain sphere.
1) Gear or piston pump. It depends on pressure which will arise during the work of system. In case of high rates, best of all to use the piston pump as it is adapted for them more. Working pressure can reach 300 atmospheres and more, in case of overloads.
2) Hydraulic distributor. Directs streams of hydraulic liquid in the necessary direction that provides management of raising of a body. Bol difficult and modern options can protect the cylinder device from excess indicators of pressure.
3) A hydraulic tank for working liquid which volume can fluctuate from 56 to 240 liters. It fastens to lateral part of a frame and has air, and also oil filters. Installation of hydraulics on the tractor means use of the minimum space with maximum efficiency. For this reason, the form of a hydrotank is optimized and optimum corresponds to installation space.
4) The Box of Selection of Power (BSP), carries out force torque transmission from transmission of the tractor to its hydraulic drive. The box of selection of power has the considerable weight and the sizes that makes necessary predesigns.
Schemes of a gidrofikation.
|One-planimetric hydraulic system
Gidrofikation of the American tractors of the FRF-FRO check point
|Double-circuit hydraulic system
Gidrofikation of the European SCANIA tractors
Installation of hydraulics - a tank with a side