This equipment is used for the rectilinear machine cut sheet threw. The used material - steel with strength on the razryena more than 450N/mm2, and also other materials, including rubber, plastic, etc. Temperature of a goryacherezanny leaf should be no more than 50 Сº.При to a full load the machine can work only in the scraper of the single machine cut. In case of operation of the equipment for the material machine cut with bigger tensile strength, material thickness should be respectively reduced.
- The frame of the machine represents an all-welded design with good rigidity, compact leading dimensions and lightweight.
- The orbit of rotation of a knife beam is inclined to the supporting surface of the lower knife forward that provides the flat and smooth line of the machine cut. Lifting bolts of an upper knife provide line tuning for minimization of agnails and a fin on an edge of the cut-off material.
- The Vprizhimny device butterfly springs are used. Also on the pressing device of a pressing plate skewback inserts from sliding are used. Pressure is more, but it does not deform a poverkhnostmaterial.
- the machine drive through the closed, autonomous transmission which is built in directly the main shaft of the drive. Constructional execution of a transmission simple, well greased, with the low noise level and long term of operation.
- In the machine there is no coupling (capture) and a flywheel. It cuts by means of the direct drive magnetic the motor reducer. It reduces idle time of the engine and saves energy
- Front and back emphasis is equipped with a scale. The back emphasis is easily adjusted by the synchronization mechanism.
|Thickness of the machine cut, mm||3,5||3,2||3,2||2,5|
|Width of the machine cut, mm||1250/1300||2000||2500||2500|
|Machine cut corner||1º 30'||1º 30'||1º 20'||1º|
|Quantity of the courses in a minute||47||47||47||47|
|The maximum number of machine cuts in a minute||10||10||10||10|
|Range of a front emphasis, mm||900||900||900||900|
|Range of a back emphasis, mm||650||650||650||650|
|Height of a table, mm||800||800||800||800|
|Power of kW||5.5||7.5||7,5||7,5|
|Net weight, kg||1440||1800||2100||2000|