- BrandSunrise Ltd
- Country of manufactureUkraine
- Length4000 mm
- Plank typeEdged
- Thickness30 mm
- Humidity8-10 %
Planed board — very valuable and it is wide - used construction material. Depending on thickness and width it is construction material can serve both for finishing and for full construction. It is necessary to understand that the planed board means a cut board from 4 parties. If the board has less than 4 sides, then it still belongs to a edged board.
Besides only the edged board humidity less than 12 percent is exposed to shaving. It allows to avoid so-called "hair" at planing (fibers of wood begin to be lifted up). Besides the dry wood is not subject to deformations and cracks. In the majority cases width of a board exceeds thickness more than twice.
The most important parameters at an assessment of a planed board:
- geometry on length and profile of a board
- quality of planing
Humidity of a planed board is estimated first of all as the simplest parameter for check. Humidity is measured from end faces of a board and in 2-3 places on board length. Humidity of a board to 14% is admissible. Besides, when using a board for example for laying of floors it will be necessary allow to adhere to the permissible moisture content where this board will be used . Planed board for floors is usually used where demands a floor with gaps for removal of moisture or just by the esthetic principles.
Planed board is widely applied in construction of furniture from the massif, fences, construction of decorative arbors and small country constructions. As you can see,is required design accuracy a planed board. For this reason the second important parameter is the board geometry. It is necessary to estimate constancy of length/width at all length of a board. "Running start" can strongly complicate installation in a design or will worsen appearance of your structure. Also it is necessary to estimate that on width and thickness of a board the plane was observed. For this purpose it is enough to put a board on a direct surface at first flat wise, and then on both edges. If the board lays down not densely, then it tells about wrong technologies of drying or storage.
Quality of planing can be estimated in places of hit of knots. Just carry out by a palm on a board if you are not hooked by fibers of wood or chips — you found the good supplier of a planed board. If you need to buy a planed board in Ukraine, it is enough to address for the one of serious producers of this material, which earned reputation from the market of timber.
|NAME||DRY 8-10%, UAH/m ³|
|under the order|
|Wooden beam, board, laths construction planed small sections (thickness. less than 29 mm)||8990,00 - 11990,00|
|Wooden beam, board construction planed average sections, (thickness. 30-45/width. 100-160)||6860,00|
|Wooden beam for construction (knots without restrictions) planed the large sections of 46 mm +||6860,00 - 8984,80|