- Country of manufactureUkraine
- Wattage11 kW
The car one-position for molding under pressure of DE3327.F1 for production of products from molding brands of thermoreactive materials with a temperature of plastication up to 432 To (150 °C).
The mode of molding pressing for receiving products of the increased accuracy and a difficult configuration is provided in the car.
FEATURES OF THE DESIGN
The double horizontal lever mechanism of locking of an original design provides a reliable smykaniye of a compression mold and differs in the small mobile masses, high rapidity. Locking with a low pressure protects a compression mold from breakages. The central mechanical pusher smoothly pushes together a finished product at the expense of different speeds of mobile and intermediate plates.
differs in high compactness. The screw drive - the high-moment hydromotor. The knot moves in the axial direction on columns by means of two cylinders of a clip.
Hydroblocks are executed on the valvate hydroequipment which is built in openings and located in close proximity to executive mechanisms. The hydraulic actuator provides smooth regulation of technological parameters.
Electronic control system
it is established by car and operates a cycle of a reaktoplastavtomat and temperature with a conclusion of all information to the display.
Diameter of the screw - 36 mm
Molding pressure - 140 MPas
Working volume - 105 cubic cm
Molding speed - 75 (cubic cm) / with
Plasticating ability on polystyrene, not less - 200 kg/h
Effort of locking - 550 kN
Plate course length - 250 mm
Height of the installed tool - 140-250 mm
The pusher course - 95 mm
Distance between columns in light, horizontal - 320 mm
Distance between columns in light, vertical - 250 mm
Working pressure - 10.5 MPas
Electric motor power - 11 kW
The mass of the car - 2300 kg
length - 3500 mm
width - 1010 mm
height - 1900 mm