- Country of manufactureUkraine
- Weight3500 kg
- Wattage15 kW
The car one-position for casting under pressure of DK3330.F1 it is intended for production of products from molding brands of thermoreactive materials with a temperature of plastication up to 432 To (150 °C).
The mode of molding pressing for receiving products of the increased accuracy and a difficult configuration is provided in the car.
FEATURES OF THE DESIGN
The double horizontal lever mechanism of locking of an original design provides a reliable smykaniye of a compression mold and differs in the small mobile masses, high rapidity. Locking with a low pressure protects a compression mold from breakages. The central mechanical pusher smoothly pushes together finished product at the expense of different speeds of mobile and intermediate plates.
differs in high compactness. The screw drive - the high-moment hydraulic motor. The knot moves in the axial direction on columns by means of two cylinders of a clip.
Hydroblocks are executed on the valvate hydroequipment which is built in openings and located in close proximity to executive mechanisms. The hydraulic actuator provides smooth regulation of technological parameters.
The electronic control system is installed by car and operates a cycle of a reaktoplastavtomat and temperature with a conclusion of all information to the display.
Diameter of the screw - 40 mm
Casting pressure - 178 MPas
Working volume - 165 cubic cm
Power of heating of the cylinder of plastication - 2.2 kW
Effort of locking - 1150 kN
Plate course length - 320 mm
Height of the installed tool - 160-320 mm
The pusher course - 105 mm
Distance between columns in light, horizontal - 400 mm
Distance between columns in light, vertical - 320 mm
Working pressure - 18 MPas
Electric motor power - 14 kW
The mass of the car - 3350 kg
length - 4200 mm
width - 1100 mm
height - 1940 mm