- BrandБрикетирующие технологии
- Country of manufactureUkraine
Biketiruyuschy press mechanical shock type used for making the preform of type "Nestro" from waste wood and other plant raw material. This type of presses is the optimum one for the briquetting of waste primary production with the least operating and production costs.
- Model - PBU - 090 - 900
- Productivity - 900 - 1200 kg / h
- Briquette diameter - 90mm
Requirements for raw materials
- The degree of comminution - 3 - 7 mm
- Humidity - 8 - 12%
The installed capacity of e lektrooborudovaniya
- Chief dvigatel - 55 kW
- Worm screw metering motor reducer - 3 kW
- Worm gear motor feed screw by compression in the chamber - 3 kW
- Heater for heating oil - 6 kW
- Engine lubrication pump - 0.75 kW
- Oil cooler - 2 × 0.01 kW
A three - phase network - 380 V 50 Hz
Length - 4,000 mm
Width - 1160 mm
cooling line briquette - 10000 mm
Masa - 5500 kg
Use of an impact press allows to make industrial and retail cake.
Press production PE "Briquetting technology" has a number of advantages in comparison with analogues produced in Ukraine:
1. Fired 400 presses units in various modifications and performance
2. In the manufacture of presses used imported components such as the motor - reducer, oil plant, oil level sensors, frequency converters, filters, cuffs, and more oil.
3. Ability to complete press additional options , such as raw material sensor in the hopper, elongation cooling line, the assembly press hopper volume of 1.5 or 3m / cc, a controller unit for the control pressure
4. The forced lubrication system, without the use of high pressure hoses for supplying oil to the working of the press - the advantage of this solution is that the press will not fail due to the high pressure hose failure.
5. The lubrication system, which prevents the press run without feeding oil to the crank mechanism.
6. On the shaft of the press roller bearings are replaced with bronze bushings - this solution can significantly extend the life of the press to conduct repairs and to reduce noise during operation of the press
7. presses are equipped with heating block and cooling oil - oil cooler allows to keep the oil temperature is not higher than 50 0 C to preserve the qualitative properties of the oil during operation of the press, heating the oil to 40 0 C for heating the oil before running the press at low temperatures
8. Presses cooling unit equipped with collets - is used to remove the excess temperature of the collet press. Required for briquetting feedstock with excess moisture.
Terms of execution of the order.
Ordering equipment is advance payment of 50% .
equipment manufacturing time is 2 - 3 months from the date of prepayment.
1 . The warranty period is 12 months from the date of shipment to the consumer press and does not cover defects which are the result of misuse, improper start and stop the use of parts that are not part of the manufacturer or making changes to the design that are not authorized by the Manufacturer.
2 . The guarantee does not apply to bearings, filters, seals, belts, screws for wear and wearing parts assembly briquetting.
3. The warranty on electrical equipment is provided under the warranty of the manufacturer of the electrical equipment factory
4. The warranty is valid subject to commissioning and staff training.
5 . The Guarantor shall not be liable for the quality of the final product produced using the supplied press, but only provides free advice on the possibilities of improving the quality of the final product.
Our equipment is included in the list of machinery and equipment for agricultural complex, the cost of which is compensated by the state budget.
Detailed information about the program is on the website of the Ministry of Agrarian Policy of Ukraine.